One-systems Cross Field Array – 2 Uživatelský manuál stáhnout pdf (Strana 1)

CROSS FIELD ARRAY-2 (CFA-2)

Long Throw/High Intelligibility

All-Weather Loudspeaker System

V100/2015

The One Systems Cross Field Array-2™ (CFA-2) was designed to provide very

high intelligibility and acoustic output where long throw requirements are

specified. The CFA-2 is a nominal 55 degree horizontal by 30 degree array that

features a fully rotatable high frequency horn/waveguide. This allows the CFA-2

to be used in either a vertical or horizontal orientation and still allows the desired

coverage patterns. The high frequency configuration consists of two large format

close-spaced compression drivers coupled to a 2” (50.8mm) constant directivity

horn. The low frequency configuration consists of 4 bandwidth optimized 10”

(254mm) diameter woofers in a 2 x 2 array. The CFA-2 is ideal for both

outdoor/direct weather long throw applications and indoor applications in high

ambient noise environments. Typical applications are football and soccer fields,

baseball fields and large theme park environments. Indoor environments such as

basketball arenas and natatorium installations are well suited due to the ultra-

high system intelligibility.

In order to achieve maximum system performance the CFA-2 should be high

pass filtered using a 4

order (24dB/octave) high pass filter set to 80Hz. This

filter frequency can be set using the One Systems SF-4 High Pass Filter system

or by using any high quality DSP based loudspeaker processor. High pass filter

frequencies as low as 60Hz may be used but maximum system dynamics and

headroom are achieved by using the recommended 80Hz filter corner frequency.

The CFA-2 is a direct weather design that features a three layer stainless steel

grill assembly. The enclosure design is a laminated fiberglass construction with

high safety factory structural rigging points molded in the enclosure shell. There

are 9 M10 rigging points and the system is supplied with a stainless steel “U”

bracket for simple suspension. The “U” bracket also includes a stainless steel

strap kit that allows the desired tilt angle to be set and maintained regardless of

wind loading.

1 2 3 4 5 6 ... 12 13

Shrnutí obsahu

Strany 1 - CROSS FIELD ARRAY-2 (CFA-2)

CROSS FIELD ARRAY-2 (CFA-2) Long Throw/High Intelligibility All-Weather Loudspeaker System V100/2015

Strany 2

The stainless steel band is connected to the “U” bracket by using one M8 bolt and flat washer on the top as shown in the close up below. A second flat

Strany 3

M10 rigging point M8 point M10 rigging M8 bolt M10 rigging point

Strany 4 - CONFIGURING THE CFA-2

The CFA-2 is shown below with both the PT-76 and the Pole Mount System EX-3. When the CFA-2 is suspended using either the Pole Mount System EX-3 or th

Strany 5

Enclosure orientation for PT-76 and Pole Mount System EX-3 Installation instructions for both the Pole Mount EX-3 and the PT-76 may be found in t

Strany 6 - CONNECTING THE CFA-2

The system is also compatible with the One Systems Pole Mount System EX-3 if vertical tilt requirements are specified in a pole mount application. Th

Strany 7 - SUSPENDING THE CFA-2

SPECIFICATIONS: Frequency Response: 60Hz – 16kHz Coverage Pattern:

Strany 8

Dimensions (H x W x D) mm: 876.5 x 572.6 x 446.3* Inches:

Strany 9

Jumpers shown in “Low Z (4 ohm)” position 2 The input routing jumpers are configured from the factory in the position shown above (Low Z). They mus

Strany 10

CONNECTING THE CFA-2 The input barrier strip wiring is shown below. NOTE the “No Connection” (NC) positions for each wiring configuration. Please n

Strany 11

SUSPENDING THE CFA-2 The CFA-2 may be suspended using either the stainless steel “U” bracket (supplied) or by using either the Pole Mount System EX-3

Strany 12

The supplied “U” bracket requires the enclosure be suspended “upside down” with the high frequency section positioned near the bottom of the front b

Strany 13

The kit consists of: 1ea. Band-it AE4779 All Purpose Band 316SS (Black Coated) 475mm long 2ea. M8 304 grade stainless steel bolts 1ea. M8 304 g

Komentáře k této Příručce

Žádné komentáře

One-systems Cross Field Array – 2 Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Akustika One-systems Cross Field Array – 2. One Systems Cross Field Array – 2 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

One-systems Cross Field Array – 2 Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Akustika One-systems Cross Field Array – 2. One Systems Cross Field Array – 2 User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Akustika One-systems Cross Field Array – 2