One-systems POPS SUBa Uživatelský manuál

PORTABLE OUTDOOR POWERED SYSTEM POPSSUBa USER MANUAL The exclamation point within an equilateral triangle is intended to alert the user to

INSURE THAT THE AC MAINS CABLE IS SECURLY CONNECTED AND IS “LOCKED” INTO POSTION. DO NOT USE THE POPSSub IF THE AC MAINS CONNECTOR IS NOT SECURLY-MA

connected to the AC mains input on POPSSub’s amplifier module. The connector on the right side of this image is connected to the AC mains supply locat

NC3FXX-HD-D. The supplied XLR to XLR audio cable has two of the NC3FXX-HD-D connectors. The POPS Sub also features a High Pass Filters output. This o

cable end is properly mated to the panel connector. To remove the XLR connector simply squeeze the rubber “boot” of the connector on the top and botto

The wiring is also shown below for the POPSSub and POPS15. From Mixer ConsoleOutput to POPS SubInputPOPS SubHigh Pass Outputto POPS 15InputPOPS 15 In

USING THE POPSSub (Application and Trouble-Shooting Tips) POPSSub is a high-quality professional sound reinforcement system designed for use in both

POPS Sub Gain EQUALIZATION The POPSSub has all the required equalization functions included in its amplifier’s

3. Verify that AC mains levels are within the required range. Voltage measurements on the AC Mains should be performed by a licensed electrician or

The POPSSub’s amplifier module MUST be serviced by an individual authorized by One Systems. POPSSub’s amplifier is attached to POPSSub’s enclosure u

The Portable Outdoor Powered System Sub (POPSSub) was designed by One Systems to provide additional bass and sub bass response for the POPS15 system.

Dimensions (H X W X D): 344.5 X 790 X 909.8 mm

Read all of the instructions included in this manual NOTE: The AC mains supply end of the POPS Sub power cable MUST be plugged into a supply sou

POPSSub’s amplifier is a convection-cooled device and requires at least 7 inches (178 mm) of clearance behind the enclosure to allow the heat sink to

Limitation of Implied Warranties ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PAR

NOTE: The POPS Sub MUST be located on level ground when the POPS 15 is mounted on top of the supplied pole. DO NOT USE OTHER SYSTEMS THAN THE POP

One Systems does not feel that adding additional EQ functions are appropriate for truly professional products. The addition of redundant functions suc

On/Off Switch NOTE: DO NOT CO